HOT WATER CYLINDERS

[basher 001]

DOES ANY-ONE KNOW WHERE I CAN FIND A SUPPLIER OFF A TRIBUNE II
HOT WATER CYLINDER AS I HAVE TRYIED A FEW LOCAL PLUMBERS
MERCHANTS IN PERTH AND THEY GOT THE CYLINDER WRONG EVERY TIME I NEED THE CYLINDER TOO HAVE BOTTOM FEED -TWO IMMERSION , ABOVE THIS TAPPING FOR RELIEF VALVE AND AT THE TOP FEED TO HOT WATER TAPS FOR GOT TO SAY SYSTEM IS A DIRECT ONE:, I HAVE HAD A QUOTE FOR STAINLASS STEEL BUT DON'T KNOW WHAT THE TAPPINGS ARE ON THE CYLINDER CAN-NOT GET ANY ONE TO LET ME SEE A BETTER PICTURE ON WEB-SITES OF SUPPLIERS:

 

[hi-spec plumbing heating]

try range cylinders.

http://rangecylinders.co.uk/tribune/

 

[basher 001]

try range cylinders.

http://rangecylinders.co.uk/tribune/[/QUOTE]THANKS FOR YOUR QUICK REPLY BUT I STILL NEED TO FIND OUT THE TECH -SPECS OR WHERE THE TAPPINGS ARE FOR COLD FEED AND IMMERSIONS ALSO RELIEF VALVE

 

[hi-spec plumbing heating]

http://rangecylinders.co.uk/tribune/direct_spec/

does this help

 

[basher 001]

try range cylinders.

http://rangecylinders.co.uk/tribune/[/QUOTE]THANKS FOR YOUR QUICK REPLY BUT I STILL NEED TO FIND OUT THE TECH -SPECS OR WHERE THE TAPPINGS ARE FOR COLD FEED AND IMMERSIONS ALSO RELIEF VALVE

TRYED WEB SITE FOR LOCAL SUPPLIER UNDER CON HEAD OFFICE FOR TRIBUNE IS KNOW IN IRELAND JUST MISSED OFFICE

 

[hi-spec plumbing heating]

your plumber may have to alter some pipework.

 

[basher 001]

your plumber may have to alter some pipework.

CAN GET CYLINDER WITH TWO IMERSION OUT-LETS COLD SUPPLY AT BOTTOM HOT SUPPLY AT TOP BUT NO OPENING FOR RELIEF VALVE COULD I GET THE RELIEF VALVE OR FIT NEW PRESSURE VALVE INTO HOT -WATER SUPPLY FOR VALVE TO VENT INTO EXSITENT OVER-FLOW

 

[hi-spec plumbing heating]

your plumber can advice on the best for you as these are a unvented system and you need a g3 cert to work on them

 

[basher 001]

your plumber can advice on the best for you as these are a unvented system and you need a g3 cert to work on them

THANK YOU FOR YOUR ADVICE I HOPE TO GET THE TYPE OF CYLINDER THAT IS FITTED BUT I HAVE TO GET A SUPPLIER BUT THIS WILL HAVE TO WAIT UNTIL MONDAY KNOW AND I WILL HAVE TO CHECK WITH PLUMBER THAT HE HAS G3 CERT?