I am an electrician in a remote area and with small know-how about appliances and no coverage of service agents! I have an LFT04, lts 1&3 flashing. Takes in water and stops once base of DW is covered.
I have checked continuity of pressure sw(ok) and tube is clear. Have removed circulating pump and all works with direct mains connected (heater also ok). I refitted and whilst on cycle I measured voltage at circ pump connector and found only 80V L-N 230V L-E (missing N?)
Also drains ok.
HELP!!
I have checked continuity of pressure sw(ok) and tube is clear. Have removed circulating pump and all works with direct mains connected (heater also ok). I refitted and whilst on cycle I measured voltage at circ pump connector and found only 80V L-N 230V L-E (missing N?)
Also drains ok.
HELP!!
