Hi all,
First time poster and have signed up as my Hotpoint washer/dryer is on the blink, literally. After a few minutes of running a cycle, all the lights at the front of the machine start flashing orange.
Machine was purchased around 2011 with only the occassional hiccup. We had to stop using one wash setting as we noticed it was tripping the circuits on the house for some reason.
I initially found this site via this thread, and took particular note of post #61 with the slight redesigned PCB. I've taken out the PCB and confirm mine looks the same. No major obvious issues with the board ie. no swelling of the capicitors etc, some places look more dirty than others (some fine black dust that easily brushes off).
Where each connection plugs into the PCB, the metal 'brass' teeth to hold the plugs look a little scorched ie. what looks like some minor burn marks. Beyond this, I can't really see anything wrong. The plugs were tightly secure when I took them out so I don't think there was a connectivity issue.
Anyone got any other idea's? I'm thinking of buying a new PCB but for the life of me cannot find what I'm looking for.
Many thanks,
First time poster and have signed up as my Hotpoint washer/dryer is on the blink, literally. After a few minutes of running a cycle, all the lights at the front of the machine start flashing orange.
Machine was purchased around 2011 with only the occassional hiccup. We had to stop using one wash setting as we noticed it was tripping the circuits on the house for some reason.
I initially found this site via this thread, and took particular note of post #61 with the slight redesigned PCB. I've taken out the PCB and confirm mine looks the same. No major obvious issues with the board ie. no swelling of the capicitors etc, some places look more dirty than others (some fine black dust that easily brushes off).
Where each connection plugs into the PCB, the metal 'brass' teeth to hold the plugs look a little scorched ie. what looks like some minor burn marks. Beyond this, I can't really see anything wrong. The plugs were tightly secure when I took them out so I don't think there was a connectivity issue.
Anyone got any other idea's? I'm thinking of buying a new PCB but for the life of me cannot find what I'm looking for.
Many thanks,
