How do I assemble this?

[Tristy]

Got this ball valve unit from wilko. But when i assemble it and push the point near the ball valve arm in, the rubber inside just comes off, there is no room for the round curcular thing to move back.

Help?

Untitled

• Tristy
• 5 Feb 2015
• 1

 

[Elkato531]

Push the cylindrical piece fully into the part that contains the washer making sure the tab lines up with the slot. The float arm should be in the down position. Next put the two parts of the valve together and screw the locking nut onto the corresponding thread. Again there should be a tab and slot to line up. Don't lift the float arm until the whole lot is screwed tight together.