1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

How to display the Miele G 1022 fault code

Discussion in 'Appliances' started by Harmonitron, 16 May 2020.

  1. Harmonitron

    Harmonitron

    Joined:
    16 May 2020
    Messages:
    4
    Thanks Received:
    0
    Country:
    Ireland
    My Miele G 1022 dishwasher when started alternately runs and stops for about five minutes and the the top three yellow LEDs which are in a vertical bar all blink at 1 Hz.

    There's a procedure for the G1040 by RichardMNZ over at this thread which gives the procedure for that model:
    1. Door shut. Dial at 12. Dishwasher turned off.
    2. Hold the start/stop button down and turn it on using the power button.
    3. Press and release the start button 3 times but hold it down on the third time until the start/stop light flashes slowly.
    4. Turn the knob to 1am and note the flash pattern. Press start/stop to see if there is more than one code. Press and hold start/stop it clear any codes.
    5. 3am is where you can test individual components
    It doesn't seem to work on my model.

    Does anyone know the fix on this model and then where to find the meaning of the code? I can't find the service manual online.

    Many thanks.
     
  2. Sponsored Links
  3. Harmonitron

    Harmonitron

    Joined:
    16 May 2020
    Messages:
    4
    Thanks Received:
    0
    Country:
    Ireland
    For anyone trying to get into the diagnostics on the G1022:

    • Close the door, power off and rotate the knob to 12 o'clock.
    • Hold the start button, press the power button and release the start button.
    • Immediately release the start button and press it five times quickly and hold it on the last push until the start LED starts blinking.
    As far as I know you can read the error code by turning the knob to 3 o'clock.

    Here's a technical manual for the G1000 / G2000 series but it doesn't specifically cover the G1022. My best guess is that Table 6-8 on page 114 is the closest for the fault codes.
     
    Last edited: 27 May 2020
  4. DIYnot Local

    DIYnot Local

    Joined:
    3 Sep 2019
    Country:
    United Kingdom

    If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

    Select the supplier or trade you require, enter your location to begin your search.


    Are you a trade or supplier? You can create your listing free at DIYnot Local

     
Loading...

Share This Page