miele

Hi, I have a 6 year old Miele W1 washing machine (WMG120 GB) which has started to report the "Waterproof" error. I am able to temporarily resolve the issue by dragging the machine out and tilting it backwards to allow the water to escape the catch tray (makes the floor wet but the machine then...

Hi, I have read through this fantastic collaborative thread and my washing machine has exactly the same symptoms, but the circuits seem completely different, so I am starting a new thread. https://www.diynot.com/diy/threads/miele-w828.130792/ My friend changed the dampers for me as the washing...

Hi, I’m new to this forum, maybe I can get some advice from the experts on this. I have a Miele W828 washing machine that works fine except for a loud noise while spinning. The drum bumps on the glass at two opposite sides. First I replaced the dampers that had no oil in them but the problem...

Miele tumble dryer 3,5 years old no longer gets warm. Also does not warm on the "warm air program". Intermittent F2 error, but this disappears and the signal from the rear NTC is good. I have done the whole round of checks, both NTCs, both heating elements, thermostat switch. Power relays...

Afternoon all, Noobie post. I've acquired a Miele heat pump dryer (T8866 WP) from the ebay, it not currently working, but I like a project! Once inside, its clear the carbon brushes need replaced and these are on order from ebay. But I want to test the other components. it was quick to get...

My Miele G1022 stops washing with three Wash / Rinse, Drying and End LEDs flashing at 1 Hz. Heater element is 25 Ω. That looks OK. Thermistor is 13 kΩ at room temperature and 2 kΩ in a cup of boiled water. That looks OK. The Schrack 0419 11 0101 02 relay shows scorching on the inside of the...

My Miele G 1022 dishwasher when started alternately runs and stops for about five minutes and the the top three yellow LEDs which are in a vertical bar all blink at 1 Hz. There's a procedure for the G1040 by RichardMNZ over at this thread which gives the procedure for that model: Door shut...

Hi. This stopped working today and I'm after some advice. Checked the thermostat and have continuity. Checked the NTC and the resistance decreases when the probe gets warm. Pulled the plug for the heater from the PCB on the front of the machine and have no resistance on one of the...

Hi all, Our Miele washing machine stopped working a few weeks ago - no lights came on. A quick search suggested the door lock switch. This was changed and the machine worked again for 4 washes. On its last wash it stopped part way though. It has the same symptoms as before - Power to the on/off...

I got given a rather good miele tumble dryer model T7934 - The previous owner was "upgrading" to a integrated heat pump variety. The problem was, they did not really look after this thing properly. They rarely cleaned the lint filter or checked/cleaned the seals. This resulted in dust making...

Hi, I've recently bought a second-hand Miele T8966WP EcoComfort heat pump tumble dryer which is ending programmes a little early saying "Clean out airways". I've cleaned the fluff & fine filters in the door and the same in the door opening, and the fine filter in front of the heat exchanger...

hi my miele g1022 dishwasher has the fill drain light flashing but not constant this has happened intermittent for about a year now all it does is start up the drain pump then goes to the light on and stops any ideas, i have checked filter for drain and clean out the none return valve in the...

The waste pipe on this tumble dryer is especially small diameter. No problem as it comes with an adapter which you put into the compression fitting - see this video; However; what do you do if you have an existing washing machine waste hose and you need to connect two hoses? I don't have room...

Hi experts, I am calling out for support as I am now at a dead end. I have issues with my tumbledryer stopping after a minute or two, then it swithes into cold air programme and starts beeping. Service mode tells me: Long blinking in 'drying' and short blinks in 'cold air' approx twice as...

I had the common Miele Dryer issue of starting a cycle then switching off after 30 seconds or so. And also the issue a cycle running but no heat. I tired the NTC switch etc and none of that worked. Finally I got a Miele engineer round and he said it was simply that the mesh vent strips that...

Hi all. Trying to find what this fault code on my T294C Dryer means: It starts up but does not heat up. Have had previous faults of starting up with heat but then shutting down after a few minutes with beeps. I have trued a new Miele NCT (temp sensor) which made no difference. Wiping the...

Hi all. I have the seemingly common fault of my Miele T294C dryer shutting down after 5 mins of blowing cold air and beeping on all settings. BUT! If I wipe / clean the door interior seal down (on the machine body side not the actual door) it will work??? Would appreciate any pointers as to...

Hi Folks I have a Miele W820 Washing Machine that's approximately 17 years old and is now not starting it's cycle (ie does not commence filling) on some Program Settings, but is ok on others. The machine starts correctly in the following positions: - In the 'Cottons' programs the 70,80&90 deg...

Miele G692 dishwasher not draining - the inlet/drain light comes on and I find that the area under the silver mesh filter in the base is full of water. When I bail out the excess water and reset the machine it carries on, sometimes until the end of the wash. If I disconnect the waste pipe from...

Whenever I start a program on Miele w842, within a few seconds the "pre-wash" light starts flashing and the program does not advance. There are washing -machine like noises coming from various parts of the machine but no water makes it into the drum and there is no spinning. There is some...