1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

Miele T8812c Edition 111 NTC measurrings

Discussion in 'Appliances' started by Ole Ottesen, 24 Aug 2017.

  1. Ole Ottesen

    Ole Ottesen

    Joined:
    24 Aug 2017
    Messages:
    2
    Thanks Received:
    0
    Country:
    Denmark
    Hi experts,

    I am calling out for support as I am now at a dead end.

    I have issues with my tumbledryer stopping after a minute or two, then it swithes into cold air programme and starts beeping.

    Service mode tells me:
    Long blinking in 'drying' and short blinks in 'cold air' approx twice as much as in 'drying'

    I have meassured the back NTC to 100k OHM, drops in hot water. Front NTC 10k, also drops in hot water.

    Must both NTC's have the same meassuring or are the ok as above?

    Kind regards
    Ole
     
  2. Sponsored Links
  3. The front and rear have different measurements.
    From memory these seem ok.

    I have had a dryer with similar symptoms.
    Check the thermal fuse has not gone and check that the relay board properly turns on.
     
    • Like Like x 1
  4. Ole Ottesen

    Ole Ottesen

    Joined:
    24 Aug 2017
    Messages:
    2
    Thanks Received:
    0
    Country:
    Denmark
  5. DIYnot Local

    DIYnot Local

    Joined:
    3 Sep 2019
    Country:
    United Kingdom

    If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

    Select the supplier or trade you require, enter your location to begin your search.


    Are you a trade or supplier? You can create your listing free at DIYnot Local

     
Loading...

Share This Page