Hi all.
Ok, so I'm just about to refit our bathroom and I'm pretty much ok with most of it, but looking at the shower head (pic below) there are no instructions on how to fit. I am presuming it screws straight into the wall plate elbow but it's the detail of this I'm not sure about. Again, I presume you locate the elbow so it's pretty much flush with the surface of the tiles when they're installed? Then you simply wrap the thread of the shower head with ptfe and screw onto the elbow? My concern is how do you know at what point the head will be tight enough? If the head is tight before the end of the thread then it won't be flush. And also, once installed it's impossible to check for leaks behind.
So just some general advice would be appreciated.
Thanks.
Ok, so I'm just about to refit our bathroom and I'm pretty much ok with most of it, but looking at the shower head (pic below) there are no instructions on how to fit. I am presuming it screws straight into the wall plate elbow but it's the detail of this I'm not sure about. Again, I presume you locate the elbow so it's pretty much flush with the surface of the tiles when they're installed? Then you simply wrap the thread of the shower head with ptfe and screw onto the elbow? My concern is how do you know at what point the head will be tight enough? If the head is tight before the end of the thread then it won't be flush. And also, once installed it's impossible to check for leaks behind.
So just some general advice would be appreciated.
Thanks.