Hi folks,
I've got a job starting tomorrow... first paid plastering job and i want to make a good go of it. The customer has seen what i can do in a house i'm renovating and wants me to do a small bit of work for him.
The job is basically this... he wants me to reskim some rough old plasterwork in his kitchen, but through the middle of the room is a big archway - a supporting wall (brickwork) which has been skimmed over, i just wanted to fix some plastic arch beads around the edges - SBR the lot - leave till the following morning while i'm doing another area and then skim the lot.
My question is, normally i would nail the angle beads through the plasterboard into the timbers in a stud wall, but how would i do this if the wall is made of brick??
thanks
Dan
I've got a job starting tomorrow... first paid plastering job and i want to make a good go of it. The customer has seen what i can do in a house i'm renovating and wants me to do a small bit of work for him.
The job is basically this... he wants me to reskim some rough old plasterwork in his kitchen, but through the middle of the room is a big archway - a supporting wall (brickwork) which has been skimmed over, i just wanted to fix some plastic arch beads around the edges - SBR the lot - leave till the following morning while i'm doing another area and then skim the lot.
My question is, normally i would nail the angle beads through the plasterboard into the timbers in a stud wall, but how would i do this if the wall is made of brick??
thanks
Dan