Hi all. Newbie here
My ancient boiler has developed a fault. It comes on from cold, but when it switches off and tries to fire up again within its time programme, it wont, unless i go out and bang the side of tne boiler.
At first, i used to switch it off and on to get it to fire up.
This morning, it failed to start from cold and i had to bang it quite hard, so the problem is getting worse.
I dont want to start repalcing the pcp board if its not that
My ancient boiler has developed a fault. It comes on from cold, but when it switches off and tries to fire up again within its time programme, it wont, unless i go out and bang the side of tne boiler.
At first, i used to switch it off and on to get it to fire up.
This morning, it failed to start from cold and i had to bang it quite hard, so the problem is getting worse.
I dont want to start repalcing the pcp board if its not that
