Hi,
I need to rest a Catnic on a single skin wall but across it so I'll only have a bearing of 100mm. It's already quite a high load (underneath a bathroom) so would prefer to get the full 150mm as an absolute minimum.
How can I up my bearing size? Was going to build an engineering brick pillar and use a starter kit to tie the two together bu not sure if I can get away with a single stack of bricks or will have to do it 2 bricks wide....?
Cheers,
I need to rest a Catnic on a single skin wall but across it so I'll only have a bearing of 100mm. It's already quite a high load (underneath a bathroom) so would prefer to get the full 150mm as an absolute minimum.
How can I up my bearing size? Was going to build an engineering brick pillar and use a starter kit to tie the two together bu not sure if I can get away with a single stack of bricks or will have to do it 2 bricks wide....?
Cheers,