- Joined
- 6 Oct 2011
- Messages
- 2
- Reaction score
- 0
- Country
Coming to the end of my install for this alarm but I have a few questions which the manual does not seem to cover.
They are:
1) I have two bell boxes and the basic wiring is fine. However, the diagram shows that one of the bell boxes has what appears to be a link from 'hold off (-)' to 'RTN'. Is this the case or something else?
2) In the 'First Power Up' chapter of the engineer's manual it says to make sure the links are connected across PA, TAMP and T-A. Thing is I already have one bell box wired into 'T' and 'A', i.e. RTN to T and Hold off (-) to A.
Am I supposed to disconnect these two wires and reconnect the link prior to firing up the system or will the bell box act as a link in and of itself?
3) Can PIR detectors face each other without malfunctioning?
Cheers,
Tom.
They are:
1) I have two bell boxes and the basic wiring is fine. However, the diagram shows that one of the bell boxes has what appears to be a link from 'hold off (-)' to 'RTN'. Is this the case or something else?
2) In the 'First Power Up' chapter of the engineer's manual it says to make sure the links are connected across PA, TAMP and T-A. Thing is I already have one bell box wired into 'T' and 'A', i.e. RTN to T and Hold off (-) to A.
Am I supposed to disconnect these two wires and reconnect the link prior to firing up the system or will the bell box act as a link in and of itself?
3) Can PIR detectors face each other without malfunctioning?
Cheers,
Tom.
