Hi,one of this weeks job i had to wire a cooker (in short) and i was getting IR test results as low as 10 meg ohms on all 3 tests.
I did sight down through the cable although most of it is clipped behind plaster.
Would be a bit of a bind to put a new radial in. But ive never had a test result this low before. And though its above the minimum result i am still questioning it.
O fcourse the cooker was discounnected and the switch was in the on postion when i done the test.
What would you do?
Thanks
I did sight down through the cable although most of it is clipped behind plaster.
Would be a bit of a bind to put a new radial in. But ive never had a test result this low before. And though its above the minimum result i am still questioning it.
O fcourse the cooker was discounnected and the switch was in the on postion when i done the test.
What would you do?
Thanks