- Joined
- 5 Dec 2012
- Messages
- 927
- Reaction score
- 13
- Country
I have just built up my oven unit, and put the oven in to see how it would work with the filler i have ben provided.
I am having the filler above the oven, because i'm having compressed laminate worktop (12.5mm thick), so need to allow a large enough gap above the oven, for the hob to fit.
I've installed the oven, resting straight ontop of the base of the carcass, and i would have epected that the filler panel would fit flush with the top of the carcass, where the worktop will sit?
Is it standard to have to cut a few mm off the filler panel to make it flush with top of carcass?
Secondly, as it's no back panel, the carcass seems very flimsy, is this also usually the case?
cheers