- Joined
- 31 Dec 2009
- Messages
- 107
- Reaction score
- 1
- Country
Finally got round to looking at the dripping cold tap in our bathroom, assuming the washer needs replacing. Should be an easy job, I've looked up videos etc. I screwed the "C" off, undid the screw underneath, pulled the cross-head off and went to remove the shroud (I think it's called that).
First problem, when I unscrewed the shroud the headgear unscrewed with it. Not the end of the world I suppose, but any suggestions how to remove the shroud from the headgear?
Second problem. I was expecting to find a grub screw holding the washer in place but the screw (or whatever it is) has no slot for flathead or philips screwdriver so I can't see how to unscrew it. Any suggestion?
Third - inside the tap, the bit that the washer screws down onto has a slightly raised rim. Not sure if it's rubber or what. Is that normal?
Greatly appreciate any help. Thanks.
First problem, when I unscrewed the shroud the headgear unscrewed with it. Not the end of the world I suppose, but any suggestions how to remove the shroud from the headgear?
Second problem. I was expecting to find a grub screw holding the washer in place but the screw (or whatever it is) has no slot for flathead or philips screwdriver so I can't see how to unscrew it. Any suggestion?
Third - inside the tap, the bit that the washer screws down onto has a slightly raised rim. Not sure if it's rubber or what. Is that normal?
Greatly appreciate any help. Thanks.