Just realised I may be doing drills wrong?

[tinpanalley]

The triangular shafts are less prone to slip than the round ones and fit a standard chuck just fine. The number of fully round drill bits I have with galling and grooves on the shaft here it has slipped in the chuck is too many.

Ok, so why do they say then that SDS ones can't be used? Aren't they essentially carved into like these triangular ones?

 

[JohnD]

Price is interesting

 

[JohnD]

Ok, so why do they say then that SBS ones can't be used? Aren't they essentially carved into like these triangular ones?

What is SBS?

 

[Mike13]

SDS have an uneven dual lobe, that does not match at all to the three way lobe of a conventional drill chuck.

This page shows the cross section of the chuck portion of an sds drill bit, note how it is impossible to get an even grab with a three jaw chuck.

Difference between SDS, SDS Plus and SDS Max drills?

What are the differences between SDS, SDS Plus, and SDS Max drills?The diameter of an SDS and SDS Plus shank is 10 millimeters. (The SDS Max is 18 millimeters. The SDS shank has the advantage of fitting into a simple spring-loaded chuck, so that bits are simply pushed into the chuck without...

www.bridgefasteners.com

 

[freddiemercurystwin]

What is SBS?

Come on have a day off the bellend cream!

 

[tinpanalley]

Come on have a day off the bellend cream!

It was a typo I corrected.
And yes, cats do rule.

 

[Mike13]

Dogs have owners, cats have staff

 

[Mr Chibs]

You can put SDS+ bits in a normal chuck, I do in my cordless, but they are tricky to centre up and get no wobble.

 

[cdbe]

I will say one thing that this does make me think of though... that frequently when I drilled into masonry, I'd find that if I set the drill to impact it would get to a point where the chuck would stop spinning. And I'd have to go the regular torque setting to have it work again and ultimately to get the hole drilled much more slowly.

I think you overlooked my comment on this - if your clutch is not re-engaging when the motor stops and is restarted and you have to switch it to the torque (non impact) setting then the drill is faulty.

 

[Deleted member 174758]

You can put SDS+ bits in a normal chuck, I do in my cordless, but they are tricky to centre up and get no wobble.

Yes, I sometimes do this when I have to drill light masonry with my combi drill, but I don't have a suitable size of smooth shank masonry bit to hand.

The thing is, an SDS bit costs more than a conventional bit, whilst delivering no advantages to the OP. A non-SDS impact drill, such as that the OP owns, just doesn't have the impact power that an SDS drill has