I have a kitchen sink waste pipe to run. The pipe exits the sink the runs externally for about 3 meters to a gulley they will be 2 elbows outside and a 45 to the gulley would you advise pushfit waste or solvent weld for this?
Kitchen sink waste pipe external
- Thread starter Fallout
- Start date
Solvent weld every time!
Andy
Andy
Thanks it elbows as it exits the wall then elbows again after about a meter. Sure the best way of glueing this as it will be tight the second elbow is up against the external corner of the house. I'll try draw a picture
Id solvent both sides of the elbow going through the wall first then would be tight to get the second elbow on the that piece. I'd have to put it together dry mark the position on the below and pipe with the angle correct. Then remove elbow and lift the pipe up pull it all out of place to glue the right hand side of that elbow?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
