My LBR 600 Dishwasher is going into alarm after 2 minutes running.
With the alarm being a start light flashing continuously, pre rinse light on and alarm beep
Any setting you try for wash will revert with above.
No heat, either the NTC, heater or pcb faulty.
As you're getting the NTC fault code I'd go with that first.
Parts aren't cheap for these machines, please bear in mind that the fault codes are only a guide to the fault. You could spend a lot of money throwing parts at the machine, more than it would cost to have someone come in and diagnose / repair the fault.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local