Hi, with regards to my plans (see previous post below) i have a small leak on one of the rad valves and intend to inject some leak sealer into the heating system. Would it be best to put the leak sealer in before or after the Fernox?
cheers
andy
Hi,
as i am renovating my house and have all the carpets and furniture out the way i thought id have a play with the heating system.
its a combi boiler (about 7/8 years old) with 6 or 8mm micro bore pipework to rads, i was thinking of removing all the rads and emptying/flushing them through with a house pipe to remove any sludge that may be in them.
i thought draining the system might block up the micro bore if there is any sludge so therefore i ll take the rads off.
then i was going to put them back, re-fill and fire some fernox super concentrate in for good measure.
Do you think this would help the efficiency/performance of my heating system ?
i might put a water softener in too.
cheers
andy b
cheers
andy
Hi,
as i am renovating my house and have all the carpets and furniture out the way i thought id have a play with the heating system.
its a combi boiler (about 7/8 years old) with 6 or 8mm micro bore pipework to rads, i was thinking of removing all the rads and emptying/flushing them through with a house pipe to remove any sludge that may be in them.
i thought draining the system might block up the micro bore if there is any sludge so therefore i ll take the rads off.
then i was going to put them back, re-fill and fire some fernox super concentrate in for good measure.
Do you think this would help the efficiency/performance of my heating system ?
i might put a water softener in too.
cheers
andy b