Leaking from tap before filling loop

[cegueira]

The filling loop seems to have started leaking from the tap handle, I have adjusted the handle slightly to slow down the leak but cant stop it.

Can I just drain down and replace it with a filling loop like this http://www.screwfix.com/p/r24-filling-loop/83905

 

[stardanny]

No, that will not fit. The valve has supply pipe coming from behind. You need a new valve set suitable for that boiler.

What boiler is it?

Daniel.

 

[cegueira]

It's a Vokera Linea

 

[cegueira]

I think the part I need is 10023567.

Should I just get this: http://www.plumbcenter.co.uk/product/vokera-10023567-c-water-inlet-valve/
from the local Plumb Centre? Is it just a case of draining down, removing the filling loop and fitting the replacement valve?

 

[polesapart]

Looks about right, but I'm not familiar with Vokeras.

You may only need to drain the water side of thr boiler.

 

[cegueira]

Hi again. I've finally managed to get the part, am planning on sorting it out tomorrow. Will I have to completely drain the central heating system to replace the valve?

 

[Madrab]

Just drain to that point, shut off the mains cold water, loosen that valve, release the system pressure and then let it drain till it stops.

 

[cegueira]

Thanks for all your help. The valve is installed with no leaks, had a bit of trouble getting the valve off until I realised there was a very rusty retention clip holding the valve onto the boiler. Should I replace this clip?