Leaking stopclock - help accessing land nut needed

[JTme]

Hey all,

I recently noticed that my stopclock tap (located under the sink in my bathroom) has started to leak from and found this site.

I've read about tightening the gland nut but can't really see it on my stopclock tap. Is anyone able to help?

An image of the tap below.
http://www.diynot.com/network/JTme/albums/12306/45980

 

[ChrisR]

It's a stop_cock
No I can't see one there either.
Could be a cheap pressed thing.
You could try warming it witha blowlamp. Hot but not enough to melt rubber inside.
Probably worth making the hole in the cupboard bigger too?

 

[Dan Robinson]

It's there - and round. Had to do harder than tthat, but making the hole bigger will make llife easier.

 

[JTme]

Thanks for the response guys. Looks like the leak was from something else so it wasn't actually the "stop_cock"