Hi there
In need of help in a big way. I have put in a new lighting circuit. It's on a 6A mcb in a split load CU. It is currently feeding one block of 6 downlights via a pull switch over 1.5mm t/e.
I have power on the phase entering the switch junction box and the switch seems to correctly send power to the lights.
BUT! the lights don't come on? I see power at the bulb holder but it doesn't energise the bulb.
have tried just connecting one light and still the same.
Could this be caused by the neutral being wired to the wrong side of the split load?
Am in a panic so all help greatly appreciated
In need of help in a big way. I have put in a new lighting circuit. It's on a 6A mcb in a split load CU. It is currently feeding one block of 6 downlights via a pull switch over 1.5mm t/e.
I have power on the phase entering the switch junction box and the switch seems to correctly send power to the lights.
BUT! the lights don't come on? I see power at the bulb holder but it doesn't energise the bulb.
have tried just connecting one light and still the same.
Could this be caused by the neutral being wired to the wrong side of the split load?
Am in a panic so all help greatly appreciated