Looking for a connector for a 1/4" stainless 304 to LDPE

[Alextrical]

Good day

I recently had my water chiller connector pop off and nearly flood the kitchen overnight. After investigating the failure, it seems that the 90degree John Guest quick connectors are not meant to be used on Stainless steel tube on the output of my water chiller.

Iceberg

The Iceberg under sink water dispenser is available as a Cold only chiller. Created especially to accommodate small spaces conventional dispensers are too large for. Measuring only 12" x 16" x 12", the Iceberg's compact design will easily fit under most sinks. An impressive output capacity of 3...

www.crystalcoolers.com

I got the unit clearance from my place of work, and it was missing the connectors, that look like the attaced image.

Can anyone advise on what type of connector that is, and a suitable replacement that can connect Stainless 304 1/4" to LDPE 1/4" ina way that it wont pop off and try to flood the kitchen again?

Kind regards
Ben J

 

[Laurieo]

You could try coming off the chrome pipe with a compression elbow .

 

[Alextrical]

So are you sugesting something like this?

I think that would work, the issue would be then connecting compression to LDPE, and would need an ferrule to prevent colapse. I think I have found some 4mm OD ferrules too that should work

304 SS Stainless Steel Elbow Double Ferrule Tube Pipe Fittings Connector 1/8 1/4 3/8 1/2 3/4 6 8 10 12mm Pipe OD Metric Thread - AliExpress 13

Smarter Shopping, Better Living! Aliexpress.com

www.aliexpress.com