This weekend I have been mostly fixing hardwood sections as edge-trim to external shiplap cladding.
Creeping towards the top of my things-to-do list is modifying the hang of my (heavy) front door.
I have little skill in the Applied Technology of Ligneous Structures but was thinking it would be useful to make a couple of pairs of wedges, and wondered if I could use bits from my h/w sections to do it. I'm hazy about dimensions and angles required.
the door swings 35mm above the concrete floor. The sections are 25mm x 55mm finished. Any good? I think I will be cutting them with a panel saw (I certainly don't have a bandsaw, and only a hand-held circular saw)
Ta!
Creeping towards the top of my things-to-do list is modifying the hang of my (heavy) front door.
I have little skill in the Applied Technology of Ligneous Structures but was thinking it would be useful to make a couple of pairs of wedges, and wondered if I could use bits from my h/w sections to do it. I'm hazy about dimensions and angles required.
the door swings 35mm above the concrete floor. The sections are 25mm x 55mm finished. Any good? I think I will be cutting them with a panel saw (I certainly don't have a bandsaw, and only a hand-held circular saw)
Ta!