Monoblock tap - tiny inflow connectors

[s_gwilym]

I bought a display kitchen from a shop that has now closed. I've come to fitting the mono-block tap but the two holes that i screw the hot and cold inlet into are too small for the threads on all the flexi-pipes i can find... the taps are italian I think.

Anyone have any ideas if i can / where i can get 'really' small threaded attachments - about 8mm external diameter?

Cheers!

 

[Terrywookfit]

Try a plumbers merchant who sells cheap crap Italian taps!!

Seriously though a decent one should stock these!!

 

[gas4you]

They usually are supplied by tap manufacturer. You should have got these with the taps when they were removed from the ex-display kitchen!

 

[Dan Robinson]

Bahco do them i think.

 

[s_gwilym]

Thank you all - the plumbers merchants I have been to just shake their heads so I guess it's a new tap block for me!

Thanks again for the advice...

 

[Dan Robinson]

I'm sure you could them.... don't chicken out just yet!!!!!

 

[s_gwilym]

Any other ideas for potential sources of these things - ?
Cheers

 

[foxhole]

http://www.screwfix.com/app/sfd/cat/pro.jsp?id=99193&ts=51319

 

[blackbob]

These should do 10mm http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=101316&ts=74249&id=27936

or these 12mm http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=101316&ts=74332&id=91351

 

[s_gwilym]

Thanks all,
I actually bought 8mm connectors and even they are too big!