Mountfield mower belt
- Thread starter calico123
- Start date
Sponsored Links
Remove the plastic shrouds that cover the blade pulleys from the deck itself.....you'll see the belt in all its glory, complete with the brake system for the pulleys which need to be pulled out of the way.
Underneath, accessing the large crankshaft pulley beneath the engine, you'll see guide rods that run close to the pulley to stop the belt from popping off. Slacken them but don't remove.
At this point you should be able to release the belt but if its too tight you may have to release the cable that tensions the blade belt by pulling on another pulley, which allows the deck to move forward a bit.
Use a genuine belt - they cost an arm and a leg but they are the best choice.
John
Underneath, accessing the large crankshaft pulley beneath the engine, you'll see guide rods that run close to the pulley to stop the belt from popping off. Slacken them but don't remove.
At this point you should be able to release the belt but if its too tight you may have to release the cable that tensions the blade belt by pulling on another pulley, which allows the deck to move forward a bit.
Use a genuine belt - they cost an arm and a leg but they are the best choice.
John
Last edited:
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
