Hi chaps,
I need to move rotate the soil stack T piece in the photo below, so that it faces down the wall in the opposite direction (i.e. rotate it 225 degrees)
I don't know much about non push-fit soil fittings from the 1990's, but I'm guessing that that existing T isn't going to want to rotate around? Will the bottom joint have been solvent welded, or is there a chance it's just a push fit in to a plastic rebate?
There's a lot of pipe work at first floor level, so lifting up the pipe work to slot in a new T fitting isn't really an option. Are there any special fittings around that can help in situations where you can't move either end of an existing soil pipe?
Cheers
Gary
I need to move rotate the soil stack T piece in the photo below, so that it faces down the wall in the opposite direction (i.e. rotate it 225 degrees)
I don't know much about non push-fit soil fittings from the 1990's, but I'm guessing that that existing T isn't going to want to rotate around? Will the bottom joint have been solvent welded, or is there a chance it's just a push fit in to a plastic rebate?
There's a lot of pipe work at first floor level, so lifting up the pipe work to slot in a new T fitting isn't really an option. Are there any special fittings around that can help in situations where you can't move either end of an existing soil pipe?
Cheers
Gary