new pipe fitting

[sidjames]

I am trying to 'tee' off from an exisisting cold pipe, I made the cut but trying to fit the tee is almost impossible because the pipe is so rigid and does not give at all. I would appreciate if anyone got any ideas?

Thanks[/b]

 

[Softus]

Various ways out of this, depending on how much of the pipe you can get at.

Personally, for speed and ease, I'd cut back the 15mm copper about a foot, then use a Hep2o coupling, a Hep2o tee, and a section of Hep2o pipe. The pipe is flexible enough to be eased into the fittings without having to

If you fancy turning the job into something bigger, then solder with a slip coupling.

Of you could just look at this and reminisce.

 

[wonderb0y]

Of you could just look at this and reminisce

mmmmmmmm peggy

 

[sidjames]

That picture brings back memories LoL!
Thanks for the tip softus it was very helpfu much appreciated.

 

[Softus]

Thanks for the tip softus it was very helpfu much appreciated.

You're welcome.

Do you suppose that that's also how Barbara thanked Sid?

Oooooh - saucy!