Hi
I've gone from imperial to metric rads and replaced the valves however one end is very wonky and is not watertight, there's a drop of water every now and again although tue valves haven't even been opened yet.
I'm guessing I need to straighten the pipe as the rad is as far against the wall as it can be. It also looks bloody terrible.
Any ideas? I was thinking about trying to bend it with a spring or cut it and join another bent piece on so it sits nicely I to the valve.
There's not much play in it and the laminate is down now so I'm in a pickle.
Thanks for any advice.
Cheers
I've gone from imperial to metric rads and replaced the valves however one end is very wonky and is not watertight, there's a drop of water every now and again although tue valves haven't even been opened yet.
I'm guessing I need to straighten the pipe as the rad is as far against the wall as it can be. It also looks bloody terrible.
Any ideas? I was thinking about trying to bend it with a spring or cut it and join another bent piece on so it sits nicely I to the valve.
There's not much play in it and the laminate is down now so I'm in a pickle.
Thanks for any advice.
Cheers