Non Plumb kitchen wall

[Adrian80]

Hi,

I have a run of units finishing against a wall, and the wall is not plumb so there is wedge shape gap at the end.

I realize your not supposed to have units butting up against the wall, but the dimensions were so tight it would have been a perfect fit.

Does anyone have any good ideas, i was thinking just fill the gap and painting it the same colour as the wall.

Well up for any better suggestions

Cheers
Adrian

 

[stephenf8542]

how wide is the wedge?

 

[Adrian80]

about 10mm at the top? the wall didnt look that bad...

 

[xerxes]

I would trim it with a length of moulding, with a round edge or chamfer on the edge away from the wall.