Hi all,
I'm in the process of replacing our kitchen, and need a little bit of guidance on the Oven.
We had an electric oven and a gas hob. The intention is to swap the gas hob for an elctric ceramic one.
Now, the cable runs from a 20amp fuse (old wire type) at the consumer unit, through the wall and into a cooker control switch with single socket. Then this goes to the cooker terminal outlet and feeds another single socket next to it for the hob.
The cable run is no more than three meters, and is in 4.0mm cable.
Obviosuly this depends on the model of oven and hob she would like to buy, but is it ok to run both oven and hob this way? Is it likely I'll need to up the fuse to 30amp?
The oven will be into the outlet, and the hob into the spur next to it
I'm in the process of replacing our kitchen, and need a little bit of guidance on the Oven.
We had an electric oven and a gas hob. The intention is to swap the gas hob for an elctric ceramic one.
Now, the cable runs from a 20amp fuse (old wire type) at the consumer unit, through the wall and into a cooker control switch with single socket. Then this goes to the cooker terminal outlet and feeds another single socket next to it for the hob.
The cable run is no more than three meters, and is in 4.0mm cable.
Obviosuly this depends on the model of oven and hob she would like to buy, but is it ok to run both oven and hob this way? Is it likely I'll need to up the fuse to 30amp?
The oven will be into the outlet, and the hob into the spur next to it