Part Arm Issues

[Bugsbunny1]

I have a Texecom Premier Elite 64 Wireless system.

All was working fine until I installed a new PIR into the utility room. It's on the system and configured. However, now when I part arm the garage the alarm is triggered when I walk by either the hall or utility PIR's.
I'm not sure if I deselected something when I uploaded to the panel. Should the garage have part 1 and part 2 omit selected?

 

[Bigsosij]

Assuming the garage is part arm 2 you will need to select part arm 2 omit for all the zones u dont want included in the part arm

 

[Jivebunny]

I’ve restored the backup i took before installing the utility PIR and the settings are identical to the attached photos. So i can either revert back to the installation by restoring the panel prior to installing the new PIR or figure out whats gone wrong.

 

[Jivebunny]

I set the utility room to part 2 omit. Set the garage to part arm and the alarm is still being triggered when i walk by the hall pir which is the entry exit.

 

[Jivebunny]

part 2 omit for the hall?

 

[Bigsosij]

Yes

 

[Jivebunny]

Sorted, thanks for the advice.

 

[secureiam]

Normally if the keypad is in the hallway, the hallway PIR is set to guard access so entry tones start if it’s passed, but depends on your layout.

 

[Jivebunny]

The PIR is in the hallway and set for a timed exit. Entry/exit1, 60 seconds with a change in tone around 15 seconds before arming its self.
Its works well allowing time to exit, and entry i think is set to 45 seconds.

 

[Jivebunny]

Deleted thread