Part arm settings on texecom premier

[homeowner27]

Hi
So the panel was originally installed by an electrician. I don't think he has programmed it correctly. Since the sensors in the bedrooms and upstairs landing don't get omitted.

When my brother in law uses the key fob to set the alarm it asks do you want to arm the system. If say no it then asks do you want to part arm the system. I say yes then it allows me to select the following
Bed time 1
Bed time 2
Evening.

My question is in the manual it says there are three part arm profiles
Part 1 omit
Part 2 omit
Part 3 omit

How do the two correlate with one another i.e. how do you know if bed time 1 is part 1,part2 or part 3

 

[sparkymarka]

Because it’s the 1st part arm , you can program the descriptor to say what you want
Eg …nightset …..dog in ….garage only …ect

 

[homeowner27]

Does anyone know exactly how you do that

 

[sparkymarka]

It’s all done via engineer mode
You would need the engineer code to access these menus
Been to multiple premier alarms installed by electricians which where half arsed programmed
Better to program these panels via a laptop with wintex

 

[secureiam]

The master user can program up the part sets not sure if they can change the part set descriptors though.

They are displayed in order, so 1 is evening arm (at default): 2 Bed 1, 3 bed 2