I am working on a diy project I got a Honeywell domonial panel and have managed to programme pirs keyfob and tag to system however I can arm the system with codes or tags but can only disarm with tags not codes has anyone got any ideas thanks
Programming help
- Thread starter Neil a
- Start date
Sponsored Links
not familiar with the system, do you have a manual?
the user has the code or fob assigned to it
I will have a look for a manual to see if I can find it.
the user has the code or fob assigned to it
I will have a look for a manual to see if I can find it.
Last edited:
The manual I found was on
Www.123securite.fr/site/doc alarms/radio/domonial
And then (pdf ekz u Ac - system-alarm professional but can't see anything in that thanks again
Www.123securite.fr/site/doc alarms/radio/domonial
And then (pdf ekz u Ac - system-alarm professional but can't see anything in that thanks again
Sponsored Links
check the user settings firstly, only place I can see where the code is on or off along with the fob.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
