When I had a new boiler fitted a few months back, they did something rather odd with the prv pipe...
Yes, that bit off pipe that comes straight down.! Is there any good reason for it not being bent towards the wall? When I get this boiler in a housing, the boxing off of the pipes underneath is going to end up so much bigger because of this pipe.
As it isn't gas, although I understand it is a safety device, can I re-pipe this myself to get it closer to the wall?
Yes, that bit off pipe that comes straight down.! Is there any good reason for it not being bent towards the wall? When I get this boiler in a housing, the boxing off of the pipes underneath is going to end up so much bigger because of this pipe.
As it isn't gas, although I understand it is a safety device, can I re-pipe this myself to get it closer to the wall?