Hi,
Could anyone advise on the installation of the of a Texecom external wired sounder to the Enforcer control panel, it mentions that I need a resistor? as below
To create the bell tamper
circuit, a resistor is
required across 0V supply
and tamper circuit of the
bell box as shown in the
diagram, the value will
correspond to the value
selected in ‘WIRING
CHOICE’. If ‘4K7 alarm,
2K2 tamper’ is selected
then the value of the
resistor will be 2K2.
Any Help would be appreciated, has anyone on this forum done this before??
Regards,
Alex
Could anyone advise on the installation of the of a Texecom external wired sounder to the Enforcer control panel, it mentions that I need a resistor? as below
To create the bell tamper
circuit, a resistor is
required across 0V supply
and tamper circuit of the
bell box as shown in the
diagram, the value will
correspond to the value
selected in ‘WIRING
CHOICE’. If ‘4K7 alarm,
2K2 tamper’ is selected
then the value of the
resistor will be 2K2.
Any Help would be appreciated, has anyone on this forum done this before??
Regards,
Alex