Pyronix Enforcer where no A/C mains present query

[jasonhayes]

Hi,

So; i have a Pyronix Enforcer but wish to install it WITHOUT mains...
I have a solar panel/battery which constantly supplied just over 11v DC

Obviously, the panel will detect no mains A/C therefore what's the best way to connect my inverter to the panel.
My pair (Pos & Neg) from inverter just comes in with no connectors therefore can i splice the battery within the panel and connect my inverter providing 13v in which the battery will be charging from the inverter NOT the AC mains controller?

I'm aware i will get mains fail warning but believe this can be suppressed. Not sure..

I also think that iif panel receiving less that 15v the Piezo will go off; sure, i could pull this but do not wish to.
Has anyone done this or made us of a WSOLDMA-12V-15V-Power-Converter which steps up 12V DC to 15V DC preventing Piezo going perhaps?

Thanks in Advance

Jason

 

[Bigsosij]

The psu is around 15vdc so would try connect in place of psu rather than battery.... then u wont have a permanaent mains failure alert

 

[jasonhayes]

Thanks

Bigsosij​

So; what your saying is remove/bypass the original Enforcer PSU board altogether.
So where i have a 13V DC solar supply use the step-up converter on the end of it to give me 15V then connect directly into the panel?

Regards,

Jason

 

[Bigsosij]

Dont see why it wouldnt work

 

[jasonhayes]

Im goanna give it a go. Let's see how reliable it is. Cheers

 

[Josh_365]

I have an enforcer on my van connected to the 12v supply and it works just fine, no need to step it up to 15v.