Pythonic enforcer v10 works supervn f1 fault

[Scottswiffen]

Hi,
My enforcer alarm has been done for almost three years. Recently the error message appear was that arming station 1 had a low battery. I swapped the battery in the keypad/ reader near the door then swapped the battery in the main alarm and now I cannot remove the following faults.
Works supervn f1
Wirles poll fail
Wireless low batt
Tamper alarm

It may be coincidence but one of the exit doors has also stopped bleeping

I have been through the engineers menu looking at the engineer reset options but I am drawing a blank.

Maybe the new battery is defective?
I may have not reset the tamper properly?

Can someone please advise.
Thanks very much.

 

[T1GERIII]

low battery in the wireless bell.

 

[Scottswiffen]

Thanks for the response but the control panel doesn’t mention siren battery low.

 

[Scottswiffen]

Please see attached pics

 

[sparkymarka]

Check battery voltage in keypad ( should be over 3.0v dc

 

[Scottswiffen]

Hi,

The battery voltage is fine. I am scratching my head with this?

 

[sparkymarka]

Does the arming station show any lights or do the keys bleep ?

 

[Scottswiffen]

Hi,

I have disconnected arming station 1 and the alarm is working again. I had changed the battery for a brand new one and checked the tamper and they seemed fine. The alarm seems to have disconnected from the home control app but I will try and resolve that separately. I am assuming that the arming station is knackered.

Thanks for your help

 

[Handymanjo]

Have you tried deleting and re learning arming station.