Hi all,
I'm at the beginning stages of installing some nice quickstep laminate in my lounge. 19m2
I have the first 3 rows down.
The trouble is, when I start a new row, the first plank goes in nice and easily.
The second I am putting in about 5 mm away from the previous, and then tapping it in to mate the short ends together..
However when I do this. Or when I coke to the end of the row and have to use the pull bar, it seems to separate the ends of some of the previous rows planks..
What am I doing wrong??
I have the. Tried going back a row and using the pull bar to get them together again, but it's becoming increasingly stubborn with the more rows attached.
I'm wondering if I should connect the entire rows ends together before properly clicking it into the previous row.
Any advise would be gratefully received.
Many thanks,
Matt
I'm at the beginning stages of installing some nice quickstep laminate in my lounge. 19m2
I have the first 3 rows down.
The trouble is, when I start a new row, the first plank goes in nice and easily.
The second I am putting in about 5 mm away from the previous, and then tapping it in to mate the short ends together..
However when I do this. Or when I coke to the end of the row and have to use the pull bar, it seems to separate the ends of some of the previous rows planks..
What am I doing wrong??
I have the. Tried going back a row and using the pull bar to get them together again, but it's becoming increasingly stubborn with the more rows attached.
I'm wondering if I should connect the entire rows ends together before properly clicking it into the previous row.
Any advise would be gratefully received.
Many thanks,
Matt