I have replaced a number of old radiator valves but the new ones are slightly smaller which leaves them about 10mm short of the pipework. The pipework is stainless steel and therefore relatively hard to bend, therefore I assume I will have to buy something like this:
http://www.screwfix.com/prods/17552...e;jsessionid=WOQXJ221N2XBQCSTHZOSFFQ?ts=83538
However, are there any other other alternatives- should I just try and bend the pipes, but I am worried that I might damage the soldered joints.
Thanks for any replies
http://www.screwfix.com/prods/17552...e;jsessionid=WOQXJ221N2XBQCSTHZOSFFQ?ts=83538
However, are there any other other alternatives- should I just try and bend the pipes, but I am worried that I might damage the soldered joints.
Thanks for any replies