just fitted some new skirtings and architraves in the whole house. What's the best way to remove/clean off some large sap rivers from the timber, before priming and painting?
Blowtorch or better still heat gun. Warm the sap up till it bubbles, then remove with a decorating knife, or a cloth, repeat until there little / none left. You may have to wait until the sap is dry, scrape / sand off any excess, and seal with knotting compund. Then prime etc.
just fitted some new skirtings and architraves in the whole house. What's the best way to remove/clean off some large sap rivers from the timber, before priming and painting?
Try Methylated spirit. This is a vg solvent remover for resin. will also clean your knotting brush. Good luck
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local