D
Deleted 218762
Hi Guys
Hope I'm ok to ask a couple of questions
I want to tile my bathroom. Boards are a bit wonky so rather than overboarding I'm planning to replace them.
Will 25mm WBP ply do the trick or does the situation warrant more?
The tiled area is 1.7m x 1.6m, 2"x7" joists at 14" centres. The boards being replaced are 22mm std T&G floorboards
Finally - the boards run right under the internal wall so I'm going to have to try to cut them halfway over the joist that runs under the internal wall.
Is there a trade trick to this or do I just have to slowly run a handsaw over and through the boards - angling the blade inwards under the partition wall in order to get my cut over the joist.
I'm not looking forward to it but its one side and 1.7m long so a bit at a time will get there eventually!
Many thanks
Hope I'm ok to ask a couple of questions
I want to tile my bathroom. Boards are a bit wonky so rather than overboarding I'm planning to replace them.
Will 25mm WBP ply do the trick or does the situation warrant more?
The tiled area is 1.7m x 1.6m, 2"x7" joists at 14" centres. The boards being replaced are 22mm std T&G floorboards
Finally - the boards run right under the internal wall so I'm going to have to try to cut them halfway over the joist that runs under the internal wall.
Is there a trade trick to this or do I just have to slowly run a handsaw over and through the boards - angling the blade inwards under the partition wall in order to get my cut over the joist.
I'm not looking forward to it but its one side and 1.7m long so a bit at a time will get there eventually!
Many thanks