I have a Risco Agility 3 alarm and I have previously replaced the keypad batteries and PIR batteries myself.
The batteries in the external sounder were running low and so I replaced them without putting it into engineer mode and I set off the Tamper alarm in the sound box. I have now replaced the batteries and put the external box all back together with the tamper switch in place but the alarm box now says "Partition 1 not Ready to set: tamper alarm in external sounder".
Can anyone please tell me how to reset the external tamper alarm fault or clear it in engineer mode because the alarm will not work at all now.
Thanks
The batteries in the external sounder were running low and so I replaced them without putting it into engineer mode and I set off the Tamper alarm in the sound box. I have now replaced the batteries and put the external box all back together with the tamper switch in place but the alarm box now says "Partition 1 not Ready to set: tamper alarm in external sounder".
Can anyone please tell me how to reset the external tamper alarm fault or clear it in engineer mode because the alarm will not work at all now.
Thanks