With fittings that seal with the rubber washer forming a seal e.g. tap tails, would they leak if they were over tightened?
In that situation, should you slacken them off?
I had this situation earlier today and my inclination was to tighten it further to stop the leak and am now reflecting on what the issue may have been…
The rubber washer is still intact.
I would appreciate your advice on this. Thanks in advance.
In that situation, should you slacken them off?
I had this situation earlier today and my inclination was to tighten it further to stop the leak and am now reflecting on what the issue may have been…
The rubber washer is still intact.
I would appreciate your advice on this. Thanks in advance.