hi all,
The receiver sits on Ideal Logic 30 boiler.
Have hot water, no heating (wasn't used since Spring)
Auto mode - tried all the tricks found on this forum, new batteries, frequency change, power off, distance, resets - have fire trigger on control module, no light on receiver, no heating.
Manual mode - click every 3 seconds. followed by 3 red light flashes. No heating. Only tried tapping and pushing the receiver to no avail.
A day before this I managed to sync and it started heating, turned off and woke up to +24 in house next morning. I suspect it wasn't synced and I might have left in on Manual mode, but still it worked somehow.
Is it a stuck relay, anything else I can try to get some heating e.g. bypass receiver and activate boiler directly? 9 degrees tomorrow and no engineer available until later next week.
Thanks
The receiver sits on Ideal Logic 30 boiler.
Have hot water, no heating (wasn't used since Spring)
Auto mode - tried all the tricks found on this forum, new batteries, frequency change, power off, distance, resets - have fire trigger on control module, no light on receiver, no heating.
Manual mode - click every 3 seconds. followed by 3 red light flashes. No heating. Only tried tapping and pushing the receiver to no avail.
A day before this I managed to sync and it started heating, turned off and woke up to +24 in house next morning. I suspect it wasn't synced and I might have left in on Manual mode, but still it worked somehow.
Is it a stuck relay, anything else I can try to get some heating e.g. bypass receiver and activate boiler directly? 9 degrees tomorrow and no engineer available until later next week.
Thanks