Hi All,
I borrowed a friends mains SDS+ drill to a bit of chiselling recently. It did fine on that. However, when I slipped in a rotary drill bit, just to see, I found that the end of the bit wobbled around somewhat. In other words, it didn't look very accurate and I think would have drilled an oversize hole in walls, etc.
Are they all like this? Or was this particular drill a bit faulty?
I borrowed a friends mains SDS+ drill to a bit of chiselling recently. It did fine on that. However, when I slipped in a rotary drill bit, just to see, I found that the end of the bit wobbled around somewhat. In other words, it didn't look very accurate and I think would have drilled an oversize hole in walls, etc.
Are they all like this? Or was this particular drill a bit faulty?