SDS Plus Drill Bit fit normal Chucks

[lordwoody]

Will a SDS Plus Drill bit fit a normal Standard Drill Chuck?

 

[big-all]

nope they will not physicaly sds drills have features like rotory stop and percution essential to make some off the sds bits function
they are also more powerfull than a normal drill driver

 

[kjacko]

I use my SDS drill bits in my Erbauer cordless drill/driver, simply because i have more sizes in SDS form. They work fine.

Is there a difference with the 'plus' then?

 

[mother]

problem is because they do not have a uniform shaft, they often do not centre properly, so a 7mm bit gives you a 9mm hole. Great in a way, less drill bits required! bad if you wnat a good fixing. Other than that they are fine, an SDS bit is made of a far higher grade of steel needed for the higher impact loads, and the imapct of sds ram. If you could hold a standard bit in an sds chuck, the impact from the ram would actually shatter the bit.

And not a lot of people know that!

 

[kjacko]

ooooh, get you!

Yeah, you're right about the SDS bit not centreing properly, i have experienced that, but as you say, its not been too bad a thing for a few holes i've need to drill.

 

[mother]

Oh and the plus is the smaller size of SDS, Max, is the bigger.

 

[disinfo]

http://cgi.ebay.co.uk/HEX-TO-SDS-AD...14&_trkparms=72:1683|66:2|65:12|39:1|240:1318

You can get an adapter, but rather pointless!