i wonder if anyone can help, i have a newlec floodlight and separate pir sensor. The pir sensor has no earth but the lamp states it must be earthed. i was going to power it straight off the fusebox without a switch? 
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
separate pir sensor and light
- Thread starter jimbob2
- Start date
You must have an isolation switch. Its in the wiring instructions.
If your wiring goes to the PIR first (it probably will) then terminate the earth conductor at the PIR in a piece of terminal block and then connect the earth on the cable going to the light.
Please be aware that if you run a cable direct from the consumer unit, this constitues a new circuit and is therefore notifiable work under Building Regulations.
If your wiring goes to the PIR first (it probably will) then terminate the earth conductor at the PIR in a piece of terminal block and then connect the earth on the cable going to the light.
Please be aware that if you run a cable direct from the consumer unit, this constitues a new circuit and is therefore notifiable work under Building Regulations.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
