Set a Galaxy 500 system correctly

[GalaxyGuy]

Hi GalaxyGuy and others

Apologies I didn't see you'd posted at #11 so didn't mean to seem ignorant. You've all given me food for thought so really, thanks again.

No worries. Hopefully, if you follow the instructions, you'll get your system sorted out.

 

[JurysInn]

Hiya

The following are in 53 PROGRAM OUTPUTS:-

1001 BELLS L
POS
---------------------------
01=BELLS

1002 STROBE L
POS
---------------------------
02=STROBE

1003 PA L
POS
---------------------------
03=PA

1004 RESET L
POS
---------------------------
07=RESET

1021 BELLS L
POS
---------------------------
01=BELLS

1022 STROBE L
POS
---------------------------
02=STROBE

1023 PA L
POS
---------------------------
03=PA

1024 RESET L
POS
---------------------------
07=RESET

_*99 E/E HORN L
POS
---------------------------
18=E/E HORN

_*10 E/E HORN L
POS
---------------------------
18=E/E HORN

_*20 E/E HORN L
POS
---------------------------
18=E/E HORN

_*30 E/E HORN L
POS
---------------------------
18=E/E HORN

Each output function had a letter L after its description
The output mode of each function is set to LATCH
Groups are disabled as in option 63

Any ideas?

 

[GalaxyGuy]

CA you post a picture of the panel pcb wiring?

 

[JurysInn]

Is that within a metal box about a foot square by two inches deep? Would any tampering be detected if I opened it?

 

[JurysInn]

I have to ask because everyone I get into engineers mode the alarm rings for a couple of seconds, thus alerting my neighbours. If I open that box I mentioned would some kind of tampering alarm go off or next time the alarm is set anyway?

 

[GalaxyGuy]

When you are entering engineering mode, it should only be the internal sounders that warn that someone is entering that mode. Entering the engineering code a second time silences the internal sounders and allows you to continue in engineering mode. In engineering mode, the system tampers are ignored, allowing you to open the panel enclosure. Please be aware that there are mains voltages present inside the enclosure, so if you are not technically competent, then it's best to get someone else to resolve your systems issues.