Hi all,
I'm retiling an existing shower enclosure in a Victorian Terrace which is brick on one side and concrete blocks on the other two. My hope was to install some sort of backing board on all three walls (or at least on the the brick wall) and then tank before tiling, however all the backer board installation guides seem to imply that I can only fix to wood framing and there simply isn't room to batten out the space (it's barely 760mm wide from bare brick wall on the right to concrete blocks on the left).
Any suggestions as to the best way to prepare these surfaces for tanking and tiling?
Thanks!
I'm retiling an existing shower enclosure in a Victorian Terrace which is brick on one side and concrete blocks on the other two. My hope was to install some sort of backing board on all three walls (or at least on the the brick wall) and then tank before tiling, however all the backer board installation guides seem to imply that I can only fix to wood framing and there simply isn't room to batten out the space (it's barely 760mm wide from bare brick wall on the right to concrete blocks on the left).
Any suggestions as to the best way to prepare these surfaces for tanking and tiling?
Thanks!